Best Aerosol Adhesives of 2026

"I found it very easy to use. I sprayed it on the items I was gluing, let it sit for a few minutes to become tacky, then pressed them together. After keeping them in place for a bit, I let them dry for about 12 hours, and it worked great! I repaired kids' lanterns on their Cinderella coach, and weeks later, it's still holding strong."

"This product arrived on time and worked just as described. I've purchased it before and likely will again. It’s easy to use and I recommend wiping the nozzle between uses for a better spray. The fumes are quite strong, so I make sure to use it in a well-ventilated area or wear a mask. Following the instructions really helps with adhesion—I highly recommend this product!"

"I've been using 3M spray 90 for over 25 years on almost every job, and it has never let me down. It works perfectly for projects with laminate and veneer. I just want to express my appreciation for 3M and Amazon for providing such a reliable product."

"I was amazed by how strongly it bonded the metal siding to the foam. After just 10 minutes, they were stuck together so well that I couldn't pull them apart. Plus, it arrived within 2 days!"

"I used this adhesive for gluing green EPS foam and reflective foil. It created a strong bond without damaging the foam like other products. The spray pattern is impressive, but be cautious of the strong fumes."

"When I rebuilt a roof for my tent trailer, I found that this adhesive really sticks great without eating the foam. However, I had a couple of cans that leaked from the nozzle, even after I switched nozzles. Thankfully, Amazon refunded me for the faulty ones."

"I've always relied on 3M products for my projects. Recently, I used their spray glue for a car headliner, and it worked perfectly. The spray was smooth, not too stringy, and I even had some left in the can after completing a large headliner. It looks fantastic, and I believe this adhesive will hold up well over time. Great product at a great price!"

"When I needed to bond thinsulate to my van walls, I turned to this adhesive, and it worked great! I only needed one can, and I even used it for other tasks, like gluing lino to bike trays for my van conversion. Super effective and easy to use!"

"I was impressed with how this adhesive sticks! It hardens like a rock and definitely works better than other options. However, I found it to be a bit overpriced for just spray glue. Be cautious when spraying, as it can leave spatters that are hard to clean off surfaces. Overall, it performs well, but the price is something to consider."

"This product is a game changer for using CA glue on my projects. I discovered it through some YouTube videos, and I can't believe I didn't know it existed before. It's a quality product that I can even spray on the outer parts of a joint as long as there's a gap for it to reach the CA glue. I appreciate using this activator alongside CA glue to act as a clamp for regular wood glue, saving me time."

"I recently tried this activator with Stick Fast CA glue on a piano repair, and I wasn't satisfied with the initial results. After ordering some expensive Gluboost Black Fill and Finish, I found that the Stick Fast Activator worked perfectly this time, and it was more affordable than the Gluboost activator. For quality finish repairs, I recommend spending a bit more on Gluboost CA, but this activator helps save some money."

"This product is incredible! The glue sets in just 10 seconds, making it perfect for quick repairs to chipped areas from a router or filling in small cracks. I love that I can fill, set, and sand within moments. I prefer using this over epoxy for small sections!"

“I used this on my son's textured wall for a fathead that was peeling off. It was a lifesaver! Fast drying, easy to use, and it saved the fathead without any problems. There was a bit of a smell, but I just had a fan and window open. I did get some on the floor, but it was easy to clean up with a hot washcloth.”

“After some uncertainty on which 3M spray to choose, I went with this one. I prepped the wall and let the adhesive become slightly tacky before applying. Make sure to cover anything you don’t want overspray on. The subway tiles are firmly in place, and I was impressed with the hold.”

“This product is the gold standard for spray glue. It offers a strong hold and uniform mist. Just be sure to use a drop cloth and spray outside, as it sticks well wherever it lands. Overall, a fantastic product for my needs.”

"I bought this to glue two throw rugs together, and it worked beautifully. My Halloween rug was a hazard as it kept slipping, staining the floor beneath. After trying a textured mat underneath without success, I applied this spray adhesive to both mats and pressed them together. It stuck well and stayed in place! Just a tip: you have to get it right the first time, as repositioning is tricky once it starts to set."

"I'm currently using this spray for various air Stone indoor wall products, and it's performing well so far. It sets quickly, and I learned to measure twice and cut once!"

"I used this adhesive to hang a paper wall border, and it holds great! It's easy to apply and allows for repositioning within the first couple of minutes. I did notice a slight odor, but it wasn't too bad. Just remember to spray carefully, as it can leave yellow marks if you're not careful."

"I followed the instructions on the can and achieved even coverage on both surfaces. After letting it dry for a few minutes, I bonded the RV slide weather shield plastic sheeting to the underside of the slide out floors, and it worked perfectly. This adhesive bonds virtually to anything!"

"Using this spray adhesive, I successfully glued a piece of 1/2” plywood to my old garage concrete. I followed the instructions closely—spraying on both surfaces and letting it get tacky—before mounting the plywood and then attaching our EV charger. It’s now solid as a rock!"

"I used this spray adhesive to attach a 5-foot long rubber mat to the bottom of my large shelf. It sprayed on easily for both the rubber mat and plywood. What I appreciated most was that it allowed me to adjust the position of the rubber mat before it set. This contact adhesive is fantastic for projects like mine!"

“I've found that this adhesive creates a very strong bond. I used it in a high heat area, and it performed great.”

“I was looking for a strong and fast-setting adhesive to fix the vinyl in my car. Unfortunately, the 3M 80 didn't work for my needs, and I ended up being disappointed with both the product and the lack of a refund from Amazon.”

“This adhesive worked wonders for me. I used it to attach rubber sheeting inside my race car fenders. After letting it dry, I was amazed that the rubber was secure and in place by morning. Another top-notch 3M product!”

"I needed to glue a non-porous plastic wireless horn switch to my classic SUV's lower dash panel. After trying several products including gorilla glue, this Loctite spray adhesive was the only one that worked. I recommend spraying it into a plastic cup and using a soft brush to avoid a mess. It dries quickly but allows for some repositioning. I've even used it for under-hood installations, and it holds up well even in high heat. It worked perfectly on my headliner sag too. 5 STARS!"

"I used this spray adhesive to bond high density foam to plywood. It worked great! Initially, I tried using a glue gun but it wasn't practical for larger projects. This spray adhesive is the perfect solution, just remember to wear a mask and goggles for safety. The first few times I accidentally touched the foam before it dried, which caused some stickiness, but I managed to fix it with scotch tape. If you get glue on your fingers, peanut butter can help remove the stickiness!"

"For my 1995 Mercedes, I applied this adhesive to the falling headliner and it worked like a charm. The spray reaches well, allowing me to cover the back of the headliner easily. It dried quickly and has been holding up for a few weeks now. If it falls, I'll update my review, but so far I'm really satisfied!"

"I needed an underlayer for my concrete floor and didn't want to glue the whole area. This spray glue was quick and easy to apply, and it has held up for months!"

"This is an excellent product! It sprays a fine mist without clumping or clogging, making it perfect for my hobby projects."

"While recovering my headliner for starlights, I found this product didn't stick well at all, nearly ruining my project. I wouldn’t buy this for headliners again."